Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Called Number Transformation - How to hide it ?

Hi,

I have configured a Called Number Transformation within a Route Pattern in order to use an alternate Telco Provider but I would like the users not to see the transformed number (cause it is like a 20-digit number instead of a 11-digit one). How would it be possible to hide this transformation and avoid showing it on the user phone ?

Thanks for your help,

Regards,

Laurent IGNATIO

3 REPLIES
Bronze

Re: Called Number Transformation - How to hide it ?

Laurent,

If you do the transformation in your route list configuration instead of at the route pattern, the end-users should not see the transformation.

Thanks,

Jim

Re: Called Number Transformation - How to hide it ?

If you do it under the Route Pattern level, users will see the modified digits. If it is done at the route list level, users will never see the transformed digits. So to accomplish make the changes at the Route List level instead of the route pattern level.

New Member

Re: Called Number Transformation - How to hide it ?

Hello,

Thanks a lot, both of you.

I will try to configure it on the Route List.

Thanks again,

Regards,

Laurent

148
Views
0
Helpful
3
Replies