Called Party Transformation

[roboliveira]

Some immediate help would be appreciated!

What I have is a CTI Port say ext. 5000

This is forwarding to a route point 7000.

In the route list I am sending it over a qsiq trunk.

Whenever I dial 5000, 7000 is presented as the called number.

I need to have 5000 presented as the called number.

Any help is appreciated.

[Chad Stachowicz]

Why are you doing it this way? Make sure what calling device you using to call 5000 has a Calling Search Space on the devices that has access to a partition containing a Route Pattern as 5000 with RL -> QSIG. The forwarding sounds unnecessary ?

HTH please share more if I'm missing something..

Chad

[roboliveira]

The 5000 is a user DID that comes in over PRI. Wen that call comes in I need to send it over the QSIG to a siemens remote shelf.

If there is an easier way to do this I am open to any ideas.

[Chad Stachowicz]

ahh this is no problem..

Create a Partition

PT-Gateway-To-QSIG

then in the gateway CSS on the incoming PRI, make sure that Incoming CSS contains this partition in it).

now make 5000/PT-Gateway-To-QSIG Route Pattern and point it to RL-QSIG..

HTH, Please rate useful posts

Chad

PS/ (Be careful not to make a routing loop in the gateway, always double check Gateway CSS..)