Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Caller get a busy tone when call to a destination

Hi, i got a Voip problem here. My user try to call from branch to HQ, it cannot reach, always get busy tone. Do you all know what step can be do to troubleshoot this issue? I check and compare the configuration with other branch seem no problem. Thanks

5 REPLIES

Re: Caller get a busy tone when call to a destination

please paste both configs here and whats your calling from where, also is this a centralized CCM or just CME's doing H323 VOIP?

Chad

New Member

Re: Caller get a busy tone when call to a destination

Branch want to call HQ but when try call HQ, busy tone heard.

attached is the configuration of branch and hq. Both of this site is using normal VOIP to do voice conversation.

Thanks a lot

Re: Caller get a busy tone when call to a destination

there is no dial-peer in the branch router pointing to 192.168.0.1 (HQ) You need to make a dial-peer with a destination-pattern of the right digits and point it to the HQ 192.168.0.1

HTH, please rate helpful posts..

Chad

New Member

Re: Caller get a busy tone when call to a destination

Hi Chad,

Thanks for reply

Do you mean dial peer like below?? It is pointing to HQ already but user complain still get busy tone when call to HQ

dial-peer voice 101 voip

description HQ TMP

destination-pattern 101T

session target ipv4:192.168.0.1 <-- point HQ

dtmf-relay h245-signal h245-alphanumeric

codec g729r8 bytes 40

Re: Caller get a busy tone when call to a destination

what number are you dialing exactly..

please run debug voi ccapi inout on both gateway and place a phone call and send it to me.

Thanks,

Chad

141
Views
3
Helpful
5
Replies