When I make a PSTN call from a Conference IP Phone, it displays "unknown caller" instead of the calling number. I have already configured "caller-id enable" under voice-port. How can this be rectified.
I am elso experiencing one-way voice when an external (PSTN) call comes to the Phone. Could this be a routing issue. Attached is the show run config and the DN of the IP Phone in concern is 5035. Pls help me out.
Re: Caller ID does not show on Conference IP Phone
Based on your description I believe you are talking about the PSTN phone that got called shows "unknown caller". From the looks of your config, it appears that your outbound calls from IP conference phone will go out of voice-port 0/1/0. It appears that the rest of the calls go out of the PRI. On a analog line, telco usually provides the outbound caller ID. The "caller-id enable" provides inbound caller ID from the telco. Telco might not be sending the caller ID for this line. I suggest that you plug an analog phone set into it and see if you get caller ID when placing a call.
You can also run "debug voip dialpeer" to check the dialpeer selection based on digits dialed, etc.
One-way voice can easily be a routing issue. Check to see if the GW can ping the IP phone.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...