Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

caller id for outbound calls

Hi,

I'm using call manager 4.2 and I've recently added a vic2-4fxo interface card to my 2811 router. All 4 lines on the fxo card are in production and are functioning properly. But...

Of the 4 phone lines each line has its own individual phone number. for example: 456-2800, 456-2823, 456-2723, 456-2832.

I'm trying to figure out how to make all 4 phone lines display the caller ID of the primary line 456-2800. I want all 4 lines to display 456-2800 on outbound calls. I'm unsure how to go about doing this... Any help is much appreciated thanks.

Regards,

Tom

1 ACCEPTED SOLUTION

Accepted Solutions
Community Member

Re: caller id for outbound calls

Hi Tom,

Caller ID blocking on outbound calls does not apply to PSTN calls through foreign exchange office (FXO) ports. Caller ID features on FXO-connected subscriber lines are under the control of the PSTN service provider, who may require you to subscribe to their caller ID blocking service.

See this link:

http://www.cisco.com/en/US/products/sw/voicesw/ps4625/products_configuration_guide_chapter09186a008080d9af.html#wp1013767

Hope this helpful, if so, please rate it!

Regards

Diego

2 REPLIES
Community Member

Re: caller id for outbound calls

Hi Tom,

Caller ID blocking on outbound calls does not apply to PSTN calls through foreign exchange office (FXO) ports. Caller ID features on FXO-connected subscriber lines are under the control of the PSTN service provider, who may require you to subscribe to their caller ID blocking service.

See this link:

http://www.cisco.com/en/US/products/sw/voicesw/ps4625/products_configuration_guide_chapter09186a008080d9af.html#wp1013767

Hope this helpful, if so, please rate it!

Regards

Diego

Community Member

Re: caller id for outbound calls

Thanks!

187
Views
0
Helpful
2
Replies
CreatePlease to create content