Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

caller-id on fxo port callmanager express 3.3

Hello,

I've a CME 3.3 on cisco 1751-V (IOS 12.4..24c).

IN the router it's installed a vic 2 fxo where is connected one analogic line.

the related voice-port has the following configuration:

voice-port 1/0
translation-profile incoming ENTRANTI
no comfort-noise
cptone IT
connection plar opx 200
!

I'need to enable the caller-id on this port (for default it is disables)  but the command is "unknown" and doesn't appears if I press  the ? key for help.

this is the list of command displayed when I ask help

POP_CSN(config-voiceport)#?
Voice-port configuration commands:
  battery-reversal     Enable FXO battery-reversal detection
  bearer-cap           Specify the bear capability
  busyout              Configure busyout trigger event & procedure
  comfort-noise        Use fill-silence option
  connection           Specify Trunking Parameters
  cptone               Configure voice call progress tone locale
  default              Set a command to its defaults
  description          Description of what this port is connected to
  dial-type            Configure type of dialer for voice
  disc_pi_off          close voice path when disconnect with PI received
  echo-cancel          Echo-cancellation option
  exit                 Exit from voice-port configuration mode
  impedance            Specifies the terminating impedance of the interface
  input                Configure input gain for voice
  music-threshold      Threshold for Music on Hold
  no                   Negate a command or set its defaults
  non-linear           Use non-linear processing during echo cancellation
  output               Configure output attenuation for voice
  playout-delay        Configure voice playout delay buffer
  pre-dial-delay       FXO Pre-dial Delay
  ring                 Number of rings
  shutdown             Take voice-port offline
  signal               The signaling type for the interface FXS or FXO
  snmp                 Modify SNMP voice port parameters
  station-id           Configure station ID
  supervisory          Configure answer + disconnect supervision options
  threshold            Threshold [noise] for voice port
  timeouts             Configure voice timeout parameters
  timing               Configure voice timing parameters
  translate            Translation rule
  translation-profile  Translation profile
  trunk-group          Configure interface to be in a trunk group

any suggest?

Thanks in advance

Giancarlo

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: caller-id on fxo port callmanager express 3.3

That card doesn't support CLID.

You need a VIC-2FXO-M2 for CLID support in Italy.

-Steve

1 REPLY
Cisco Employee

Re: caller-id on fxo port callmanager express 3.3

That card doesn't support CLID.

You need a VIC-2FXO-M2 for CLID support in Italy.

-Steve

412
Views
0
Helpful
1
Replies