Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Caller-ID showing unknown on outbound calls through POTS

I am running CM 4.2 with an MGCP gateway at one of our remote sites. We have a POTS line setup. When one of our users dials a local number, the call shows up "unknown xxx-xxx-xxx" The number shows up fine.

I talked to the Telco twice and they said they have tested their side and the name of our business shows up when they test it. But this does not work when we dial from our side.

Does anyone know of anything that would block the name on our side from showing up on calls?

Thanks

  • IP Telephony
1 REPLY
New Member

Re: Caller-ID showing unknown on outbound calls through POTS

We called out from the FXS port and the name showed up correctly. But the IP phones are showing unknown.

124
Views
0
Helpful
1
Replies
This widget could not be displayed.