Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Caller ID with Call Manager 7 and MGCP controlled GW with FXO port

I saw many topics discussing problem of Caller ID  on FXO port with MGCP cotrolled gateway.

It was NOT supported  by call manager 6

Is it supported on Call Manager 7 ? ( i recently upgraded to CCM 7 )

Or Caller ID sitll is not important feauture for cisco ?

I have 20 remote officess with 2911 gw controlled by MGCP and i would liek to avoid if possible switching them to H323

Thanks in advance for any informative response

It could be nice to hear any answer from cisco TAC .

2 REPLIES
New Member

Re: Caller ID with Call Manager 7 and MGCP controlled GW with FX

Caller ID on MGCP gateways with FXO ports was added to the 8.0 release.  See the link for the new features added in version 8.0.  I do not have the version notes here but you will also need to make sure the IOS on your routers can handle the new feature.

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/rel_notes/8_0_1/delta/nc-801-cm.html

Re: Caller ID with Call Manager 7 and MGCP controlled GW with FX

Hi,

Hope this document clarifies the situation, essentially CLID is supported for MGCP FXO in 12.4(20)T or later and CUCM 8.0:-

http://www.cisco.com/en/US/prod/collateral/routers/ps259/product_data_sheet0900aecd8057f2e0.pdf

Hope this helps

Regards

Allan.

725
Views
0
Helpful
2
Replies