After the customer uses CCMUser to CallForwardAll on Line6, should the 7961 show a animated CallForwardAll icon flashing with a arrow? I want to say in the past it did show a animated icon. I?ll have them check the Calling Search Space. I?m not clear if when they dial this line it call forwards or not. They just indicated the animated icon isn?t working -jason
I thought that this was a very good question that I had never thought of so I just tried this out. On two different phones a 7941 and 7961 I did a CFWDALL from ccmuser on secondary lines on the phones. The Icon does not come on in these scenarios. The Icon only works with the Primary Line 1.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...