I have MGCP gateway, it has Vic2-4FXO , one FXO ports has analog line that is connected to Telular, the Incoming calls to an IP phone through this port shows Unknown Number for the Calling ID, I tried to change the related service parameters related to the calling ID, with no luck.
The debug voice ccapi in out at the gateway shows that the calling ID received , but when call arrives the IP phone the calling ID shows as unknown number
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...