Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

calling ID Restriction

When dialling out from the local sites using 2821 ROUTER CLID is still being forwarded. BT the bri supplier have provided cli with held at the local exchange.

1 REPLY
Hall of Fame Super Gold

Re: calling ID Restriction

And the question is ?

Using CallManager, the clir is restricted by a checkbox somewhere is the configuration.

In all the other cases, if you want CLIR (calling number information restricted), configure "clid restrict" in the outbound dial-peer. The outgoing setup message will be then like:

ISDN BR0/0/0 Q931: TX -> SETUP pd = 8 callref = 0x40

Bearer Capability i = 0x8090A3

Standard = CCITT

Transfer Capability = Speech

Transfer Mode = Circuit

Transfer Rate = 64 kbit/s

Channel ID i = 0x89

Exclusive, B1

Progress Ind i = 0x8183 - Origination address is non-ISDN

Calling Party Number i = 0x00A0, '28293031' <-- NOTE i is set to 0xA0 to mean CLIR

Plan:Unknown, Type:Unknown

Called Party Number i = 0x80, '68783347'

Plan:Unknown, Type:Unknown

Sending Complete

172
Views
0
Helpful
1
Replies
CreatePlease to create content