03-16-2009 04:08 PM - edited 03-15-2019 04:53 PM
I am connecting CUCM 6.1 to Teltronics PBX 2020 via Cisco 2800 gateway with E1 ETSI PRI
I configure the 2821 gateway as Primary-Net5 ISDN Switch type
Calls between PBX and CUCM are ok but calling name doesn't appear
When the digital phone call ip phone, I tried to debug isdn q931 and i can see the calling name in the debug
Locking Shift to Codeset 7
Codeset 7 IE 0x28 i = 0x01, 'I.GHALAYIN', 0x00000000000000000000
Anyone can help me ?
Regards
Mohamed
03-18-2009 08:02 AM
The only codeset the CUCM understand is "0". Have the PBX team to set the codeset to "0". This feature is configured in the PBX Trunk-Group configuration page. Also, if the PBX supports Supplementary Services, set the Supplementary Service Protocol to "a"
MK
04-06-2009 08:01 AM
PBX Engineer told me they don't have paramter called "CodeSet " !!!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide