Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Calling-Name H323 - Not Showing on Phones

Hello All,

I'am having an issue where when using H323 on a 2851 gateway with CUCM 7.1.2, the calling name does not show up on the phones. Now I have done some research on this and I have configured the following. I read that the h225 command "h225 display-ie ccm-compatible "is now integrated into the IOS". Do I need to switch to a code that has the command as a configurable option? I have checked with telco and they are sending us the calling name in the setup messages, I do not see it in the H225 q931 debugs. Any help would be much appreciated thanks!!

voice service voip

signaling forward unconditional

h323

interface Serial0/0/0:23

no ip address

encapsulation hdlc

isdn switch-type primary-ni

isdn incoming-voice voice

isdn supp-service name calling

flash:c2800nm-advipservicesk9-mz.124-25a.bin"

3 REPLIES
New Member

Re: Calling-Name H323 - Not Showing on Phones

Everyone, I rolled back to IOS 124-11.XW10.bin and inputed the following commands and now calling-name works.

voice service voip

h225 timeout ntf 300

h225 display-ie ccm-compatible

Has anyone gotten H323 calling-name to work with a new IOS where these commands are apparently integrated into the IOS?

New Member

Re: Calling-Name H323 - Not Showing on Phones

Hi,

were you able to display the called name?

thanks for your feedback,

Bronze

Re: Calling-Name H323 - Not Showing on Phones

This command helped me get it working on 15.0(1)M2

396
Views
5
Helpful
3
Replies