Though the user A turns off mobility by himself , when he makes the call to any internal voip call manager treats the call as internal and shows his associated ip phone number instead of mobile phone number.
If i change the mobile number , ie add 123 to the mobile number in RD , call manager routes the call thro gateway and other end able to see full mobile number.
Is this as per cisco set up? if the user turns off the mobility then the mobile number should not be associated and the receiving end should get exact calling number instead of ip phone number.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...