I am having this weird issue with Calling Party number displaying my BTN on outbound calls. My route parttern is set to "Use External calling party number" My phone is set to the correct external calling party info. This is a new site and I never put the BTN number into the config. But when I do a dubug isdn q931 "calling party number" is my BTN to the telco???? Could the telco be doing this because I have looked over my Router Pattern/RG/RL/Gateway and I do not have this number listed anywhere. Ideas?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...