cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
983
Views
0
Helpful
1
Replies

Calling Party Transformation and MGCP

fossilev700
Level 1
Level 1

I am running System version: 7.0.2.23900-4. Calling Party Transformations are not taking effect on MGCP GW. The exact same config works if I change the GW type to H323.

I am attempting to set the caller-id to 201-201-2000 but it is not taking.

The PSTN is not restricting caller id.

Calling Party Transformation Patterns
201201XXXX    hq-calling-xform-out           
2XXX    hq-calling-xform-out
Calling Party Transformation Mask 2012012000

Route Pattern Configuration
9.[2-9]XXXXXX
Use Calling Party's External Phone Number Mask is unchecked


System-RL specifies local route group
Route group config:
Use Calling Party's External Phone Number Mask is set to off

GW configuration
Use Device Pool Calling Party Transformation CSS is unchecked

Calling Party Transformation CSS
    hq-gw-calling-xform-out
Partition: hq-calling-xform-out

Calling phone 2001 external phone mask 20120122XXX
the caller id being sent to the PSTN is 2001

thanks

1 Reply 1

fossilev700
Level 1
Level 1

Issue resolved by doing a no mgcp / mgcp on the gateway. I had rebooted the gateway but apparently mgcp must be reset when a change is made to the calling party transformations...its always something simple

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: