I was wondering if there was a patch to install or do I need to have TAC remote into the server still. The problem I have is the customer has a data network and a VOIP and the VOIP does not have Internet access and he will not allow it either. So I was wondering if there was a patch that I could install to resolve the problem. I ran accross another Forum Topic like this and there was a reply stating the TAC sent him this file:
but it doesn't say if that fixed the issue, I also could not find this on there download site.
We ran into the same issue and Cisco provided the patch. When you applied the updgrade, do the 1st node first then 2nd, 3rd. The original OS will still remain in the HDDs but now you will booting to the 2nd active partition for each server. After you upgrade the cluster, try to to the backup again and it should work fine. We use a utility that was very streight forward for backup and I think Cisco also recommends, called FreeFTPD.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.