Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

CallManager 5.1 DHCP

Sorry if my question is quite basic, but how can I check the current DHCP leases under CallManager 5.1? I have a suspicion I have exhausted one scope.

Thanks in advance,

Paul

4 REPLIES
Bronze

Re: CallManager 5.1 DHCP

For this requirement use the command " show network " with parameters. for more information refer the following url,

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a008079bbfa.html#wp1026032

Silver

Re: CallManager 5.1 DHCP

Anyone have an answer to this? I tried every show network command to no avail.

Re: CallManager 5.1 DHCP

Probably not the answer you are looking for, but unfortunately as far as I know you are unable check the dhcp bindings using the administrator CLI access, this can only be done using the root username and password which only TAC can help with. :(

Regards

Allan.

Silver

Re: CallManager 5.1 DHCP

Alan,

Thanks for the (non) answer. :) If it turns out to be true, then there is no good reason to use the DHCP server in CUCM. There's probably a perfmon statistic somewhere, but I don't know of any documentation on any (ok, very few) of those values. I'll check around RTMT to see if there is anything of value there.

Afrankel:

CallManager (Communications Manager) 6.0(1a) in my case is configured as a DHCP server (DHCP Monitor Service). I want to determine what clients (Phones) got what IP addresses from the DHCP server.

Thanks

159
Views
5
Helpful
4
Replies
CreatePlease to create content