Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Callmanager 7.1.3 NTP third generation phines

     I have a callmanager Business Edtion 7.1.3. When I set the NTP on the server all is okay.I can set a timezone offset and the server and ntp status are correct.

When I set up a ntp referenece for the phones and create a DTG, the newer phones (7945g) will not display the

correct time. It is like they are iginoring the offset, No matter what I try.. I ended up removing all ntp references and setting the time on the server to the correct time and all is okay.

Is this a bug in 7,1.3 fixed in 7,1.3a or do upi need an offset file on the phone,?

7 REPLIES

Re: Callmanager 7.1.3 NTP third generation phines

What time zone are you using?

New Member

Re: Callmanager 7.1.3 NTP third generation phines

I am eastern time zone

Red

Re: Callmanager 7.1.3 NTP third generation phines

This is a feature instead of a bug.

On CUCM 7.1.3, the timezone architecture was changed so it'll be more adaptive to future DST changes.

If your phone's firmware version is lower than 9.0 (which I guess it is), you'll have to choose a timezone with the * at the end.  The timezone without * at the end will only work with firmware 9.0 and above.

What timezone have you choosen from CUCM DTG?

Michael

http://htluo.blogspot.com

New Member

Re: Callmanager 7.1.3 NTP third generation phines

I had to remove it so I will go back and check to see.. Thank you.. I know that the

third generation phones do the offset calculation now and I seen something about a file on the phoneon the release

notes but I couldn't see where to get the file.

You are right Iam at 8.5 I think which was anothe issue.Let me verify.

New Member

Re: Callmanager 7.1.3 NTP third generation phines

I used GMT -5:00 America/Toronto which does NOT have the *.. So what you are saying

is if I change the dtg to   GMT05:00 America/New York * it should work

??

If so thank you

Red

Re: Callmanager 7.1.3 NTP third generation phines

Yes, if you use New York *, it'll work.

Michael

New Member

Re: Callmanager 7.1.3 NTP third generation phines

I will test.. I tried everything and ended up backing out the NTP on the server as I was stuck..

I will let you know

662
Views
0
Helpful
7
Replies
CreatePlease login to create content