I have one router which is configured as MGCP and where i have two connections for the PSTN : 1 PRi and Two BRI but i'm asking if i can use the BRI as a bachup i mean the preference 0 would be the E1 and the preference 1 would be the BRI for outband call thanks for replying.
note: i was thinking to add the router twice where each one i only include the erquired card and then in the route group i just divide one for E1 and the second for the BRI
So i have one gateway that have one PRI connection to the PSTN and TWO BRI and i want to use my Voice gateway for outband calls using the PRI and in case of failure or busy signal switch to the BRI on the same router so can anyone tell how can i do that with Route Group?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.