Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CallManager Express - G729 for remote phones

Hi All

Is there a way to force remote phones to use g729 and allow local phones to use g711.

We are running cme 4 and are now experimenting with remote phones (ip communicator) for home users. I want all IP Communicator's to use g729 because they are going over vpn connection. I've tried:

ephone ?

Codec g729r8

but unless both local and remote phones are set like this then calls fall back to g711.

Regards

Tony

3 REPLIES
Hall of Fame Super Gold

Re: CallManager Express - G729 for remote phones

That's not what I see on my CCME 4.1. I see that IP Communicator (not over VPN) uses g.729 with the default ones that are set for g711.

Re: CallManager Express - G729 for remote phones

I'm not sure if you done this or not, but you can change the IPC to optimize for bandwidth. Its one of the settings under preferences.

Hall of Fame Super Gold

Re: CallManager Express - G729 for remote phones

Correct, I may have done that and forget about.

228
Views
0
Helpful
3
Replies