Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CallManager Express

Hi,

I'm using a CallManger Express on Cisco 2821. Here are my questions regarding the E-991:

What type of interface is required for the router/Call Manager for 911, (DID) Direct Dial? and is our system configured for that interface?

What is configuration requirements are needed if each IP Addressable Telephone is to be uniquely identified from the Call Manager to the 911 Center?

3 REPLIES
Hall of Fame Super Gold

Re: CallManager Express

Hello,

how do you connect to PSTN ? You need ISDN BRI or PRI for each telephone to be identifiable by the called (911 or not)

New Member

Re: CallManager Express

I'm connected to PRI, but in case of emergency call i think the IP-PBX will be located. We have some phones way far from the IP-PBX location, so if the emergency call is coming from one of these phones, how we locate the phone. This is our issue, and we want to know if there is any system we can apply for that.

Hall of Fame Super Gold

Re: CallManager Express

Hi,

Perhaps someone else has better experience on this (lot of good advice on 911 matters if you search the forum).

I imagine that you can communicate to the emergency center the exact locations of your extensions so they it in some database, but this is only a supposition on my side.

109
Views
0
Helpful
3
Replies