I have a CCM cluster v4.1(3) and 2 CMM modules on 2 Catalyst 6506 configured as MGCP gateways. Each CMM module has 4 PRI interfaces connected to the PSTN.
Both voice and fax calls come throuth these PRIs. We recently purchased a RightFax server v9.3 with a Brooktrout TR1034 card that we want to integrate with the CCM and Exchange.
I need some assistance designing this integration. Follow my questions:
1- After doing some research on the CCO, I found that the only way to keep the MGCP configuration on the gateways (which is required) is to configure Cisco Fax Relay mode instead of T.38 mode.
Are there any drawbacks in using Cisco Fax Relay instead of T.38? Has anyone tried this configuration before?
2- The requirement is for each CCM phone user to have its own fax line. Could the user fax number be the same as the phone number or do we need to use a different number for voice and fax calls?
3- We also have a Unity Voice Messaging already installed which can be upgraded to unified messaging if needed. Are there any advantages or additional funtionality if we integrate unity with the fax server?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...