Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Callmanager with MGCP Gateway

I am having problem with the configuration of a PRI circuit on a MGCP 3825 VGW. When testing, the carrier is up but the D-Ch is down (hard per the Carrier). I have changed each Protocol type, but haven't been successful. Is there a setting in the VGW that has to be set on the port?

NOTE: We have order new circuits from a different carrier. The existing PRI is good with (B8ZS, ESF NI2) New carrier requires 5e Custom. That's the only change.

1 REPLY
Cisco Employee

Re: Callmanager with MGCP Gateway

can you post the relevant config and a sh isdn status??

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
90
Views
0
Helpful
1
Replies