Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Callmanagers different HDD Firmware

CCMPUB01 HDD Firmware versions Kind of Drive

Port 2 : SCSI ID 0, Internal HPB2 SCSI

Port 2 : SCSI ID 1, Internal HPB5 SCSI

Port 2 : SCSI ID 2, Internal HPB5 SCSI

Port 2 : SCSI ID 3, Internal HPB2 SCSI

CCMSUB01

Port 2 : SCSI ID 0, Internal HPB5 SCSI

Port 2 : SCSI ID 1, Internal HPB1 SCSI

Port 2 : SCSI ID 2, Internal HPB2 SCSI

Port 2 : SCSI ID 3, Internal HPB2 SCSI

CCMSUB02

Port 2 : SCSI ID 0, Internal HPB9 SCSI

Port 2 : SCSI ID 1, Internal HPB9 SCSI

Port 2 : SCSI ID 2, Internal HPB2 SCSI

Port 2 : SCSI ID 3, Internal HPB2 SCSI

CCMSUB03

Port 2 : SCSI ID 0, Internal HPD5 SAS

Port 2 : SCSI ID 1, Internal HPD5 SAS

Port 2 : SCSI ID 2, Internal HPD5 SAS

Port 2 : SCSI ID 3, Internal HPD5 SAS

CCMSUB04

Port 2 : SCSI ID 0, Internal HPD5 SAS

Port 2 : SCSI ID 1, Internal HPD5 SAS

Port 2 : SCSI ID 2, Internal HPD5 SAS

Port 2 : SCSI ID 3, Internal HPD5 SAS

I have 5 servers. 3/5 have different HDD firmware and was wondering if this is safe to run with old and new hdd firmware.Can you pls provide me this information.

1 REPLY

Re: Callmanagers different HDD Firmware

The official answer that you would receive from Cisco, HP, and/or IBM is that you should run consistent firmware across all systems. In addition, they also recommend that you run the same speed of drive at least on a server level - i.e., all drives are 10k or 15k - not mixed and match.

Unofficially, at a previous company I've been at we had 8 CCM clusters one of which was a fully loaded cluster. Over the years, we ended up with mixed firmware and mixed drive speeds and there was no clear indication that it specifically caused any issues.

133
Views
0
Helpful
1
Replies