cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
532
Views
0
Helpful
3
Replies

***********************Calls rejected************************

CrazyDonJuan
Level 1
Level 1

Hi Pros

The following dial-peer keeps rejected all the calls- I means I got busy tone:

dial-peer voice 86008 voip

description -- send to OpenSER

translation-profile outgoing voip_toll_range_204

huntstop

destination-pattern 40345088..$

progress_ind setup enable 3

voice-class codec 1

session protocol sipv2

session target sip-server

dtmf-relay rtp-nte

playout-delay nominal 250

playout-delay mode fixed

ip qos dscp cs5 media

no vad

!

We use this dial-peer for GrandStream analog adapter. My sip server shows that the phone 8843 is resgistred with the server and downloaded the proper firmare. However, my PRI GW keep denis the calls. There an ouput from the PRI GW

Time elapsed since last clearing of voice call statistics never

Connect Time = 3303358, Charged Units = 0,

Successful Calls = 4, Failed Calls = 71, Incomplete Calls = 0

Accepted Calls = 64, Refused Calls = 0,

Last Disconnect Cause is "39 ",

Last Disconnect Text is "bearer capability not authorized (57)",

Last Setup Time = -1512913577.

: 4034508843 Digits: 11

I called my PSTN service provider, they said that they send us the call and our PRI denies it.

Any ideas why the PRI denies these calls?

Thanks in advance,

Crazy

3 Replies 3

paolo bevilacqua
Hall of Fame
Hall of Fame

To know, take debug isdn q931 and debug ccsip message with term mon.

I enable debug isdn q931 and debug ccsip all then I called the number; however, there is no debuging message. And of course, type terminal monitor since I telnet to the device.

Check "show log", level logging to console can have been changed.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: