Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

Cals out FXO give fast busy

I make a test call and via debug vpm signal I see the following on 2821/FXO controlled via MGCP. If I plug my buttset into this Bell 1FB/POTs line I can make calls fine.

ROUTER-2821-01#

Sep 9 16:12:56.251: htsp_timer_stop3 htsp_setup_req

Sep 9 16:12:56.255: htsp_process_event: [2/0/8, FXOLS_ONHOOK, E_HTSP_SETUP_REQ]f

xols_onhook_setup

Sep 9 16:12:56.255: [2/0/8] set signal state = 0xC timestamp = 0

Sep 9 16:12:56.255: htsp_timer - 1300 msec

Sep 9 16:12:56.507: htsp_process_event: [2/0/8, FXOLS_WAIT_DIAL_TONE, E_DSP_SIG_

1100]fxols_power_denial_proc

Sep 9 16:12:56.507: htsp_timer2 - 1000 msec

Sep 9 16:12:56.507: htsp_timer_stop

Sep 9 16:12:57.507: htsp_process_event: [2/0/8, FXOLS_WAIT_DIAL_TONE, E_HTSP_EVE

NT_TIMER2]fxols_timer2_proc

Sep 9 16:12:57.507: htsp_timer_stop

Sep 9 16:12:57.507: htsp_timer_stop2

Sep 9 16:12:57.507: [2/0/8] set signal state = 0x4 timestamp = 0

Sep 9 16:12:57.511: htsp_process_event: [2/0/8, FXOLS_ONHOOK, E_HTSP_RELEASE_REQ

]fxols_onhook_release

ROUTER-2821-01#

1 REPLY
Bronze

Re: Cals out FXO give fast busy

Do the FXO end-points show as registered?

What version of CCM are you running?

Can you run the following debug one at a time and make outbound call?

debug mgcp packet

debug vtsp all

353
Views
0
Helpful
1
Replies
CreatePlease to create content