Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

can anyone explain to me line by line , Thanks

Setting Parameters

show voice port 2/0:0

Type of voice port is cas

Operation State is DORMANT

Administrative State is UP

No Interface Down Failure

Description is not set

Noise Regeneration is enabled

Non Linear Processing is enabled

Non Linear Mute is disabled

Non Linear Threshold is -21 dB

Music On Hold Threshold is Set to -38 dBm

In Gain is Set to 0 dB

Out Attenuation is Set to 0 dB

Echo Cancellation is enabled

Echo Cancellation NLP mute is disabled

Echo Cancellation NLP threshold is -21 dB

Echo Cancel Coverage is set to 8 ms

Echo Cancel worst case ERL is set to 6 dB

Playout-delay Mode is set to adaptive

Playout-delay Nominal is set to 60 ms

Playout-delay Maximum is set to 250 ms

Playout-delay Minimum mode is set to default, value 40 ms

Playout-delay Fax is set to 300 ms

Connection Mode is normal

Connection Number is not set

Initial Time Out is set to 10 s

Interdigit Time Out is set to 10 s

Call Disconnect Time Out is set to 60 s

Ringing Time Out is set to 180 s

Wait Release Time Out is set to 30 s

Companding Type is u-law

Region Tone is set for US

Station name None, Station number None

  • IP Telephony
4 REPLIES
Hall of Fame Super Gold

Re: can anyone explain to me line by line , Thanks

For any command output, check the reference manual.

Re: can anyone explain to me line by line , Thanks

each one is self explanatery

which one u have doubt...

better to look i runniing config voice port conf

New Member

Re: can anyone explain to me line by line , Thanks

Probalbly my question should read , what is the set up recommandation as we a have a voice delay to the work station , I also do have spaning tree configured w/ 4 switches , so I am trying to see where the delay is

Thanks again

Hall of Fame Super Gold

Re: can anyone explain to me line by line , Thanks

work station ? please clarify.

147
Views
3
Helpful
4
Replies
This widget could not be displayed.