Can I terminate a SIP trunk on an existing MGCP gateway?
Running CUCM 7.1.5 and currently have a Cisco 2811 with 3 PRI circuits as a MGCP gateway. We are bringing in a SIP trunk from our telecom provider for evaluation and I was wondering -- can I use that same router to terminate the SIP trunk handoff from the telco without affecting any of the existing PRI circuits?
As I understand, you don't need a voice gateway for a SIP trunk, correct? It is simply defined in CUCM. All I need is a place to terminate the Ethernet handoff the telco is going to give me. Am I on the right path?
Thanks, I have never done SIP trunking before so this is all new to me.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...