Can i use MGCP gw as a h323 gw in the same time ???
as you can see in the subject I have a mcgp gw with PRI ISDN card and it is used by UC1 system with CUCM. Now, I want to use this gw/PRI with an another UC2 system (uc500), but in this situation gw is going to be h.323.
Since gw has just one LAN interface , can i designate this interface to be h.323 interface without impact to UC1 (MGCP) ???
Re: Can i use MGCP gw as a h323 gw in the same time ???
you cannot have 1 PRI do both mgcp and h323 once the l2 is backhauled to CUCM in mgcp there is no more h323 on that gw. However you can have the router do 2 protocols simultaneously for eg you can have 2 PRI's one doing MGCP and 1 doing h323
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...