Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Can not route incoming call to CCM

Hi everybody,

I have a Cisco CCM 6.1 cluster and 2 Cisco Voice Gateways. I try to make incoming call from PSTN to my IPPhone. But, it is not successful. Pls review my call flow:

PSTN----GW(10.149.80.253)---CCM (10.149.89.12/10.149.89.13)---0999

------------------

Cisco Voice Gateway Configuration:

voice translation-rule 4

rule 1 // /0\1/

voice translation-profile EditCallingIncoming

translate calling 4

!

voice translation-rule 3

rule 1 /^18001091/ /0999/

voice translation-profile 18001091

translate called 3

!

voice class codec 1

codec preference 1 g711alaw

!

interface Loopback0

ip address 10.149.80.253 255.255.255.255

h323-gateway voip interface

h323-gateway voip bind srcaddr 10.149.80.253

!

dial-peer voice 100 pots

tone ringback alert-no-PI

description IN/OUT POTS

translation-profile incoming EditCallingIncoming

destination-pattern 0.T

progress_ind setup enable 3

progress_ind alert enable 8

progress_ind progress enable 8

direct-inward-dial

port 7/0:D

!

dial-peer voice 201 voip

tone ringback alert-no-PI

description IN/OUT VOIP

translation-profile outgoing 18001091

destination-pattern 1800T

voice-class codec 1

session target ipv4:10.149.89.13

incoming called-number .

dtmf-relay h245-signal h245-alphanumeric

!

!

dial-peer voice 202 voip

tone ringback alert-no-PI

description IN/OUT VOIP

translation-profile outgoing 18001091

destination-pattern 1800T

voice-class codec 1

session target ipv4:10.149.89.12

incoming called-number .

dtmf-relay h245-signal h245-alphanumeric

------------------------------------------

CCM Trace log:

/11/2012 15:55:38.243 CCM|H225Handler::SdlConnectionInd, rejecting the TCP connection from IP=10.149.80.253. Incoming H225 call on Port=1720, can't find this port in the registered H323 endpoints port list. |<CLID::StandAloneCluster><NID::10.149.89.12><CT::0,0,0,0.0><IP::><DEV::><LVL::Error><MASK::0100>

04/11/2012 15:55:38.445 CCM|H225Handler::SdlConnectionInd, rejecting the TCP connection from IP=10.149.80.253. Incoming H225 call on Port=1720, can't find this port in the registered H323 endpoints port list. |<CLID::StandAloneCluster><NID::10.149.89.12><CT::0,0,0,0.0><IP::><DEV::><LVL::Error><MASK::0100>

04/11/2012 15:55:39.270 CCM|H225Handler::SdlConnectionInd, rejecting the TCP connection from IP=10.149.80.253. Incoming H225 call on Port=1720, can't find this port in the registered H323 endpoints port list. |<CLID::StandAloneCluster><NID::10.149.89.12><CT::0,0,0,0.0><IP::><DEV::><LVL::Error><MASK::0100>

04/11/2012 15:55:39.849 CCM|H225Handler::SdlConnectionInd, rejecting the TCP connection from IP=10.149.80.253. Incoming H225 call on Port=1720, can't find this port in the registered H323 endpoints port list. |<CLID::StandAloneCluster><NID::10.149.89.12><CT::0,0,0,0.0><IP::><DEV::><LVL::Error><MASK::0100>

04/11/2012 15:55:45.381 CCM|H225Handler::SdlConnectionInd, rejecting the TCP connection from IP=10.149.80.253. Incoming H225 call on Port=1720, can't find this port in the registered H323 endpoints port list. |<CLID::StandAloneCluster><NID::10.149.89.12><CT::0,0,0,0.0><IP::><DEV::><LVL::Error><MASK::0100>

04/11/2012 15:55:45.741 CCM|H225Handler::SdlConnectionInd, rejecting the TCP connection from IP=10.149.80.253. Incomin

I tested to make local call to 0999, it is OK.

Anybody explain for me?

Thanks

Thuc

3 REPLIES
Blue

Can not route incoming call to CCM

Hi

Just to ask one point. What is the DN configured in CUCM you are calling from PSTN.

Is the partition of DN in Gateway CSS. Is h.323 Gateway  added in Cisco CUCM.

Send us debug isdn q931 of failed call.

Regards

Ronak patel

Regards Ronak Patel Rate all helpful post by clicking stars below the answer.
New Member

Can not route incoming call to CCM

Hi Ronak,

This Configured DN is for IVR application. I tested local call for this DN, it is OK. And I make outgoing call via the GW properly as well. So, I don't think the issue in  ISDN connection. H.323 Gateway is added in Cisco CUCM.

Actually, the CSS of H.323 GW has one Translation Pattern ( Translation Pattern: XXXX, : Allowed, Calling Name Presentation : Allowed, Calling Search Space : Normal_CSS ). The Normal_CSS included 0999.

Any ideas?

Thanks

Thuc

Hall of Fame Super Silver

Can not route incoming call to CCM

Can you post "debug isdn q931" for this call?

Chris

288
Views
0
Helpful
3
Replies
CreatePlease to create content