I accidently de-activated all of the services from on the Callmanager 6.0.1 via browser (ccmadmin)except "callmanager" and "tftp" process. Now I can't access the appliance using the web browser. is there a way to get the system back (using CLI or else) so I can web into the appliance again?
â¢service-name represents the name of the service that you want to stop or start:
-A Cisco DB
-Cisco Database Layer Monitor
-Cisco Unified Serviceability
â¢enable enables auto-restart.
â¢disable disables auto-restart
â¢show shows the auto-restart status
Using a Command Line Interface to Start and Stop Services
You can start and stop some services through the Command Line Interface (CLI). For a list of services that you can start and stop through the CLI and for information on how to perform these tasks, refer to the Cisco Unified Communications Operating System Administration Guide.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...