Can't Block Incoming Number

[justins]

I'm having trouble blocking an incoming number on a Cisco 2811 configured as an h.323 gateway. I followed this guide here - http://blog.ipexpert.com/2009/03/21/blocking-calls-based-on-ani/. Everything seems to work okay. I can even successfully test the translation rule (test voice translation-rule 1 123), but when I call the main number with the phone that's supposed to be block, it still goes through. What am I doing wrong?

[Suresh Subramanian]

Could you please post the debug voice ccapi inout output with the related translation rules and dial-peer configurations? Please include the calling and called numbers too.

[justins]

05-12-2014 11:15:02 Local7.Info ip_address 153457: May 12 16:13:19.975: %ISDN-6-CONNECT: Interface Serial0/3/0:0 is now connected to 555-555-5555 N/A

05-12-2014 11:14:58 Local7.Info ip_address 153456: May 12 16:13:14.875: %ISDN-6-CONNECT: Interface Serial0/3/0:0 is now connected to 555-555-5555 N/A

05-12-2014 11:14:58 Local7.Info ip_address 153455: May 12 16:13:14.875: %ISDN-6-CONNECT: Interface Serial0/3/0:0 is now connected to 555-555-5555 N/A

05-12-2014 11:14:58 Local7.Info ip_address 153454: May 12 16:13:14.871: %ISDN-6-CONNECT: Interface Serial0/3/0:0 is now connected to 555-555-5555 N/A

[Suresh Subramanian]

Could you please collect "debug voice ccapi inout" for the test call?

[justins]

I did, but how do I retrieve the log?

[Suresh Subramanian]

https://supportforums.cisco.com/document/62906/how-properly-and-safely-collect-debugs-ios-router

[justins]

Attached is the log you requested.

[Suresh Subramanian]

Could you post the running configuration? What is the calling and called numbers?

[justins]

I attached the config. Why do you need the calling and called numbers?

[Suresh Subramanian · Accepted solution]

Hello Justin,

I don't see the translation-rule in the attached configuration.

if you would like to block the specific calling number, please configure the translation rule and apply it to the inbound dial-peer as instructed in this URL.

http://www.cisco.com/c/en/us/support/docs/voice/call-routing-dial-plans/64020-number-voice-translation-profiles.html#con13

you may also refer this post for further information

https://supportforums.cisco.com/discussion/12116111/blocking-calls-incoming-calls-gateway-router?tstart=0

if the call is still not rejected, please collect the "debug voice ccapi inout" for a test call and include the specific calling number & called number to verify which translation rule and dial-peer they macth.

//Suresh

Please rate all the helpful posts.