I installed and configured IP Telephony. When I entered the phone number with and without dialing a 9 first, and press the Dial Button, it doesn't then. After a few seconds, it just exited. I checked my configurations and everything looks good.
Thank you for your reply. Yes, I am new at this. We are VoIP with Cisco IP Phone 7960. I have purchased a version of 18.104.22.168 of IP Communicator (SoftPhone) that I installed on my pc and using the number pad of my keyboard to dial my cell phone for testing, to test for our offsite workers. I have prepared and configured my Cisco Call Manager and gotten my softphone to able to grab ldap configration, from the look of it the softphone able to open without error. When I enter a phone number with a 9, and without, and then press the Dial button or press the Enter key on my keyboard, it doesn't dial.
Below is from my Call Manager.
Cisco IP Communicator
Registered with Cisco Unified Communications Manager VMS-CUCMBE
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...