Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Can we run mgcp and h323 protocols in a single voice 3845 gateway router

Hi to everyone,

It would be greatful if you guys guide me here pls..

Can we run both mgcp and h323 protocols in a single voice 3845 gateway router ?

thanks

shiv

2 ACCEPTED SOLUTIONS

Accepted Solutions

Re: Can we run mgcp and h323 protocols in a single voice 3845 ga

Hi Siva

I don't believe I've ever read anything that recommends against this.

However I have seen customers with this setup, I'm not sure exactly what your trying to do but from experince the only issue I have ever seen with this is where there is srst configure using:  application mgcpapp

The reason is if you put a h323 dial-peer before the application mgcpapp dial-peer, it will never invoke the MGCP dial-peer as it looks from a top down order.

You may beable to change with this the dial-peer hunt however if you order your H323 dial-peer after the application mgcpapp
you shouldnt' have any issues.

Re: Can we run mgcp and h323 protocols in a single voice 3845 ga

Hi

The MGCP autogenerated dial-peer prefix can be changed if so desired, ordinarily MGCP dial-peers are generated as 999????.  The following command allows you to change this prefix, however as already stipulated you need to be wary of the order in which they are created:-

ccm-manager config dialpeer-prefix prefix (select a prefix number other that the default 999)

Regards

Allan.

Hope this helps, pls rate helpful posts.

5 REPLIES

Re: Can we run mgcp and h323 protocols in a single voice 3845 ga

Yes, this is done all of the time. Well, maybe not all of the time but enough to make it a common place configuration.

HTH.

Regards,

Bill

HTH -Bill (b) http://ucguerrilla.com (t) @ucguerrilla

Please remember to rate helpful responses and identify

New Member

Re: Can we run mgcp and h323 protocols in a single voice 3845 ga

Thanks for your quick reply.But couldnt get a single document which illustrates such scenario.

Is it a recommended / advisable by Cisco ?

thanks

Re: Can we run mgcp and h323 protocols in a single voice 3845 ga

Hi Siva

I don't believe I've ever read anything that recommends against this.

However I have seen customers with this setup, I'm not sure exactly what your trying to do but from experince the only issue I have ever seen with this is where there is srst configure using:  application mgcpapp

The reason is if you put a h323 dial-peer before the application mgcpapp dial-peer, it will never invoke the MGCP dial-peer as it looks from a top down order.

You may beable to change with this the dial-peer hunt however if you order your H323 dial-peer after the application mgcpapp
you shouldnt' have any issues.

New Member

Re: Can we run mgcp and h323 protocols in a single voice 3845 ga

Oh;Ok.

Thank you so much guys for your quick update.

Re: Can we run mgcp and h323 protocols in a single voice 3845 ga

Hi

The MGCP autogenerated dial-peer prefix can be changed if so desired, ordinarily MGCP dial-peers are generated as 999????.  The following command allows you to change this prefix, however as already stipulated you need to be wary of the order in which they are created:-

ccm-manager config dialpeer-prefix prefix (select a prefix number other that the default 999)

Regards

Allan.

Hope this helps, pls rate helpful posts.

386
Views
9
Helpful
5
Replies