Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Can you use the range command for T1's?

I'm trying to reset roughly a few dozen T1's.....This might take a while, is there a range command that I can use similar to the int range command for interfaces?

1 ACCEPTED SOLUTION

Accepted Solutions
Purple

Can you use the range command for T1's?

Hi Ricci,

I do not think so.

You need to individually enter into controller port and do the shut/no shut or if T1s are coming from a single card of MUX of SP, then, that card could be reset.

regds,

aman

1 REPLY
Purple

Can you use the range command for T1's?

Hi Ricci,

I do not think so.

You need to individually enter into controller port and do the shut/no shut or if T1s are coming from a single card of MUX of SP, then, that card could be reset.

regds,

aman

104
Views
0
Helpful
1
Replies
CreatePlease to create content