We have 2 numbers of PVDM3-32 .At the moment we are using 45 channels for the E1 PRI only.So can I use rest of the free 15 DSP from the PVDM for configuring the MTP or required a dedicated PVDM for this MTP configuration?.Attached show diag and show run in my earlier post.
Please let me know how to configure MTP in cme.
If you can provide any sample config. would be highly appreciated.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...