I have a CME running on C2900 Software (C2900-UNIVERSALK9-M), Version 15.2(4)M4, RELEASE SOFTWARE (fc2). What i have noticed that even though I have telnet and ssh enabled, sometimes the CME will not allow me to access the device. But I can still access via the CME webpage. The only way I ever solve is is by rebooting the device.
1) Has any ever gotten the to root cause of this problem?
You have to make sure you have all your VTY channels set to pick up Telnet and SSH. Do a "Line Vty 0 ?" and check how many VTY channels you have. Then choose all channels "Line vty 0 X" X being the number that you get in the last line. Finally do a "Transport input all".
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...