Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cannot add a 7970 to CUCM 7

I recently installed CUCM 7.0.1.11000-2 using the demonstration license. We've attempted to add a 7970 and a 7961 for testing but the web page hangs until it times out and the phones are not added. I am able to add a 7940 or a 7960 without an issue. I've done a complete reinstallation twice (I'm on my third installation) and I always get the same issue. (BTW, these are the only 2 phones on the system...it's not out of licenses)

<br />

<br />Has anyone seen this before or have some guidance?

<br />

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: Cannot add a 7970 to CUCM 7

I ran into a similar problem like this, can you check your Network card Duplex settings and make sure your UCM servers match the switch, both in configuration and what they are actually running at.

I found I have a duplex mis-match and I got the same problems, I could update . Change / add a 7940 /60 but not any of the 41/42/45s

As soon as I fixed the mismatch everything worked fine…

2 REPLIES
New Member

Re: Cannot add a 7970 to CUCM 7

I ran into a similar problem like this, can you check your Network card Duplex settings and make sure your UCM servers match the switch, both in configuration and what they are actually running at.

I found I have a duplex mis-match and I got the same problems, I could update . Change / add a 7940 /60 but not any of the 41/42/45s

As soon as I fixed the mismatch everything worked fine…

New Member

Re: Cannot add a 7970 to CUCM 7

That fixed it up…I don't understand why…but it did. Thank you very much for your help!

103
Views
10
Helpful
2
Replies