07-17-2008 11:02 AM - edited 03-15-2019 12:02 PM
Hi all,
I am getting an error when trying to make a conference call to another office. If I go to the PSTN and make a conf call it works.
I looked at the region codec's and they say to use g.729 to the other regions
CCM 4.1.3, h.323
Thanks,
Randall
Solved! Go to Solution.
07-17-2008 11:22 AM
Configuring Enhanced Conferencing and Transcoding for Voice Gateway Routers
http://www.cisco.com/en/US/docs/ios/12_3/vvf_c/interop/intcnf2.html
CallManager and IOS Gateway DSP Farm Configuration Example
HTH
javalenc
if this helps, please rate
07-17-2008 11:06 AM
most probably you're using a SW conference bridge that only supports G711.
Add a XCODER or use a HW CFB
HTH
javalenc
if this helps, please rate
07-17-2008 11:19 AM
Thanks,
How do I add an xcoder?
Thx
Randall
07-17-2008 11:22 AM
Configuring Enhanced Conferencing and Transcoding for Voice Gateway Routers
http://www.cisco.com/en/US/docs/ios/12_3/vvf_c/interop/intcnf2.html
CallManager and IOS Gateway DSP Farm Configuration Example
HTH
javalenc
if this helps, please rate
07-17-2008 12:03 PM
Here is another question. The user just said it works on his desk phone but not P Comm. 2.0
Thanks,
RC
07-17-2008 12:07 PM
it probably has the optimize for low BW configured under the IPC preferences on the computer
that checkbox causes IPC to use G729
HTH
javalenc
if this helps, please rate
07-17-2008 12:09 PM
I initially tried that, with no luck.
RC
07-17-2008 12:20 PM
When the 2nd call answers i press the confrn button. Should there be a join button in the template? Maybe I have the wrong button.
Thanks,
RC
07-17-2008 12:36 PM
join is used when you establish calls using the hold, new call method. if doing conference press cnf 1 time, dial then press cnf again to connect parties
HTH
javalenc
if this helps, please rate
07-17-2008 12:49 PM
OK, just wanted to check.
so why would the desktop work and not the IP Comm.
07-17-2008 12:52 PM
MRG, MRGL, no access to the SW CFB, IPC and CFB in different regions
HTH
javalenc
if this helps, please rate
07-17-2008 02:38 PM
I am looking at the MRGLs. US has 2 groups. China has 3. The top group in the China list is the china resource group and the other 2 are the same as US.
Thanks,
RC
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: