I Made new Implementation of IPT with CUCM 8.0 (Pub and 1 Sub) and H323 Gateway. Calls are working fine, But When I make Conference call Internally It fails. Suppose from Phone A I called Phone B, Phone B Answer Call. From Phone A I press Conference Button and Dial Phone C, phone C Answer the call, Now from Phone A I press Conference Button Again to have Conference it fails either all call dorp or it revert back to resume Call to Phone B.
I have Software Conference Bridge and also Hardware Conference bridge configured and registered in CUCM. config is below, Conference Bridge is assigned to proper MRG and MRG is assign to Proper MRGL which is assigned to proper Device pool. we have tested conference in one region and codec is g711, this is new IPT installation.
sccp local BVI1
sccp ccm 10.188.248.6 identifier 1 priority 1 version 7.0
sccp ccm 10.188.248.5 identifier 2 priority 2 version 7.0
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...