Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

cannot put DTMF when I call

Hello,

I use Call Manager and have a voice gateway. They are relyed by SIP trunk.

So When I call from the Call Manager to external call, there are an IVR in the called number.So i have to put many digit.

But the problem is that I cannot put the digit.

What is the problem?

The schema is :

CCM <-IP SIP Trunk -> Voice Gw <- E&M -> Router <-IP H323-> Voip Call

Thank you

  • IP Telephony
4 REPLIES
New Member

Re: cannot put DTMF when I call

What happens when you try to enter the first digit? Can you send me a copy of your config on the voice gateway?

Cisco Employee

Re: cannot put DTMF when I call

do you have configured the DMTF relay for NTE and sip-notify on the applicable dial-peers

in order for the GW to relay the DTMFs you need to configure it on the dial-peers and also what kind of DTMF is going to be relayed

HTH

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Re: cannot put DTMF when I call

The trunk with the call manager 5 is a SIP.

The dtmf preference is RFC 2833.

And in the gateway router is rtp-nte, that is RFC2833 too.

Should I replace it with sip-notify?

New Member

Re: cannot put DTMF when I call

Hello,

The phone is a 7971G. With a 7911G I can use the dtmf, i can enter digits when the menu ask me.

But with the 7971G, I just hear a beep in the phone when I enter the digit menu.

Many Thanks.

166
Views
0
Helpful
4
Replies
This widget could not be displayed.