I have a bit of a strange scenario, i have a cluster 6.X and users in one site are unable to transfer calls internally. They get "your call cannot be completed as dialled" as soon as the second digit of the seven digit extension is pressed. They are able to transfer externally, put calls on hold etc so i would think that rules out the DSP`s...i have checked the dial plan there are not any patterns matching the seven digit extensions that block the call from being routed.
I have seen another post where there was an identical issue on CCM 5.X but i think this should affect all sites not just one.
CSS and Partitions are all correct and in the correct place.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...