I configured a service for Meetingplace Express and assigned it to a template in BAT. I pushed the service out to all my phones successfully, however, if I go in through the user options page and try to update the parameters of the service to configure it, the settings dont save.
If I remove the service from the phone and then add it back using the device config page I am able to successfully update my settings through the user page. It seems like a bug in BAT and I was seeing if anyone else has had this issue.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...