I'm running through some possible changes to my network and there's something I'm not entirely clear about. What would happen if I have a setup like this:
Route List Generic-RL
Route Group H.323 gateway
Route Group Multiple MGCP T1's
Let's say the H.323 gateway only has 1 PRI. Now I have 23 calls up (the PRI is full). Now I need to send another call out the Route List. Is there anyway to have it go to the second RG instead of sending it to the one for the H.323 and just failing due to lack of capacity?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...