Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CCM 3.3 and 4.1 - support for ISDN BRI cards

Hi all,

I don't see the option to add the VIC2-2BRI-NT/TE card in CCM 3.3 and 4.1 as an MGCP endpoint. I select the Cisco 2811 as the MGCP gateway, and whether I choose to add the module in the VWIC slots, or in a NM-HDV module, the VIC2-2BRI-NT/TE is not an option.

Can anyone please help as this is urgent.

Much appreciated. Thanks.

2 REPLIES

Re: CCM 3.3 and 4.1 - support for ISDN BRI cards

MGCP BRI is supported in CCM 4.1(2) and later.

"MGCP BRI Endpoint Configuration

Cisco CallManager 4.1(2) adds a basic rate interface (BRI) endpoint configuration window on the MGCP Gateway Configuration window. The new configuration window contains configurable BRI MGCP backhaul parameters and hardware-specific parameters that you may use to configure a BRI endpoint on the IOS gateway.

Configuration Tips (for Administrators)

?Cisco CallManager 4.1(2) includes support for new network modules. (Refer to the following documentation for additional information.)

?This release provides support only for ETSI BRI basic-net3 (user side only). "

From this doc:

http://cisco.com/en/US/partner/products/sw/voicesw/ps556/prod_release_note09186a00802b434f.html#wp2034293

As a workaround you can set up your gateways as H.323.

BR,

Stoyan

New Member

Re: CCM 3.3 and 4.1 - support for ISDN BRI cards

Thanks,

I was hoping I could apply a patch or a service release to resolve this problem.

106
Views
0
Helpful
2
Replies
CreatePlease login to create content