Thanks a lot sir. My GW support H323 and SIP. I configured as H323 in my CCM, but there is something wrong, when I try to establish a call to a cell-phone, it rings 2 times and then the call is dropped.
The GW has the local Device Pool and a unrestricted CSS.
Thanks again sir, according to the guide, it is FastStart compatible (sorry, I don't understand the meaning). My IP phones are in the same region that the GW iGATE (G711) and I'm testing with one remote region (g711 in the remote region and g729 with the others regions).
Is there any special configuration in the GW page to do?.
Thanks again dear sir, I'll collect the necessary traces today and I let you know the results in a few hours.
Just one more question please. I have 3 MRGL, the first one include SW resources, the second list include HW resource only and the third list includes HW and SW (actual MRGL). If I change the MRGL in the GW config page to MRGL-SW-ONLY and I check the MTP required, an ip phone to a cell-phone call is normal. It could be a resource problem?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.