Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CCM 4.1(3)sr2 with a Siemens Hicom via QSIG

Hi guys,

we are running our call manager with a dedicated E1 and another 37xx Link to our other site in Germany. Most features work fine now after we set the Hicom to EcmaV2 QSig and changed the routers to ISDN contiguous-bchan.

The final hurdle now is that after a connect the Hicom in Germany looses the 0-00xxx on an Incoming call from London (we then show only the DN)

Feb 20 18:32:34.262: ISDN Se1/4:15 Q931: TX -> CONNECT pd = 8 callref = 0x8045

Facility i = 0x9FAA06800100820100A116020102020102800E5374656666656E2042616965722E

Connected Number i = 0x0081, '58999'

and from Germany to London we miss the 0-00 and it just displays 4969xxx.

Feb 20 18:36:18.150: ISDN Se1/4:15 Q931: RX <- CONNECT pd = 8 callref = 0x8D79

Facility i = 0x9FAA068001008201008B0100A10F02024F4002015530068204061C0840

Facility i = 0x9FAA068001008201008B0100A12102024F50020102A118041342414945522C205354454646454E20564F4950020101

Connected Number i = 0x1180, '496971367138'

I have attached 2 Traces

1 REPLY
Silver

Re: CCM 4.1(3)sr2 with a Siemens Hicom via QSIG

Try the CSS for the calling PSTN numbers placed in the CSS for Inbound Calls in the Gateway configuration.

100
Views
0
Helpful
1
Replies