To create a phone with his extension open the CCMAdmin web page in CCM then go to Device --> Phone --> Add new phone. Select the phone model that you have and add the phone, put the MAC address of the phone and select the Device Pool and the Phone button template that you want to use and insert the phone. Now add your DN (this extension will be the same in Unity) and select the Partition and CSS that you want, just make sure that the CSS can reach the partiton of the VM ports and the VM pilot or you can select on your Forward options a CSS that can reach those.
Then on Unity open the SaWeb and create a Subscriber (the phone's user) and put the same extension that you put on the phone in CCM.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...