Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CCM 4.1/ Route Group not showing my SIP trunk as an option

I am trying to setup a route group that will use both a SIP trunk and an ICT. Basically if the SIP trunk is down or not receiving connections, I would like the call to route to the ICT. The only problem is that when I create the Route Group, it does not show my SIP trunk as an available device to choose from. Is this standard? How can I add it?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: CCM 4.1/ Route Group not showing my SIP trunk as an option

Sounds like your SIP trunk is being used in a route pattern. If it is used in a route pattern, it is no longer available to be added to a route group and vice versa.

Hope this helps. If so, please rate the post.

Brandon

2 REPLIES

Re: CCM 4.1/ Route Group not showing my SIP trunk as an option

Sounds like your SIP trunk is being used in a route pattern. If it is used in a route pattern, it is no longer available to be added to a route group and vice versa.

Hope this helps. If so, please rate the post.

Brandon

New Member

Re: CCM 4.1/ Route Group not showing my SIP trunk as an option

Thank you Brandon, this worked!

200
Views
10
Helpful
2
Replies